OVERVIEW
The C600 mainstream ETCO2 sensor is the latest mainstream ETCO2 sensor. It need not warming up. C600 can recognize all kinds of adapters, no matter new or abrasive adapters. The C600 is designed specifically for mainstream measurement of CO2 using sophisticated infrared absorption spectroscopy. the measurements are taken at the patient airway at a sampling frequency of 100 Hz. It uses the same interface to the patient monitoring system as the C300 Side stream CO2 Module making it easy to configure a patient monitoring system with CO2 monitoring technology that is affordable and easy to use.
HIGH LIGHTS
● Better CO2 wave form and more accurate ETCO2, RPM reading.
● Good resist beating ability.
● The communication protocol of C600 is compatible with Respironics or Phasein.
● Remote upgrade ability.
● Better policy of after service. Manufacturer promise 2 years warranty.
● Long life infrared source and detector.
● Lower dew-point temperature, significantly reduce condensation on the adaptor.
Medical use of the product
The C600 CO2 Sensor is used to continuously monitor carbon dioxide and report ETCO2, inspired CO2 and respiratory rate of the intubated and non-intubated adult, pediatric, infant and neonatal patient. For use in monitoring patients in respiratory distress, respiratory arrest or that have asthma, COPD or other disorders where the patient ETCO2 and capnogram will benefit the caregiver in the treatment of the patient. For use in monitoring patients pre- and post-intubation.
To assist in the setup, management and weaning of the patient that is connected to a conventional mechanical ventilator.
Order information
Whole set of C600 ETCO2 module include:
- one sensor,;
- one adult airway adapter;
- one infant airway adapter.
If you need a development kit, there are more components in addition, one serial cable, one power cable, one connect tooling and one test program.
|
